Wright Serial #62995 and higher Manuale Utente

Wright Manufacturing Inc. Instruction Manual Wright Manufacturing 4600X Wedgewood Blvd Frederick, Md 21703 Wright ZTO serial # 62995 a

8 WARNING WARNING WARNING 1.10 Prevent Fires Machine fires and structural fires can occur if a machine is stored before allowing it to

9 WARNING WARNING WARNING WARNING • All operators of this mower should exercise caution when driving this mower at high speeds. Sud

10 WARNING WARNING 1.17 Operation on Slopes DO NOT operate on steep slopes. DO NOT operate the mower on slopes steeper than you can feel se

11 WARNING WARNING 1.19 Hydraulic Safety The hydraulic system on the Wright ZTO is not equipped with high pressure hydraulic hoses or any ex

12 76490050 DECAL, FIRE HAZARD WARNING 76490088 DECAL, Warning Label - Fuel 76490089 DECAL, Danger Label - Fuel 2 Warning, Safety and Instructional

13 Warning, shield missing, DO NOT operate with shields missing. Keep shields and covers in place.Warning, rotating blades, Keep hands, feet and c

14 Width (Deflector Down) 49" (59") / 124 cm (150 cm)Length 78" (198 cm)Weight 1015 lbs (460 kg)Width (Deflector Down) 53" (63&q

15 4 Machine Description & Overview The Wright ZTO is meant to solely cut, bag or mulch grass. The use for any other purpose is not recommended

16 4.1 Model and Serial Location 1. The plate is affixed on the right side in the engine compartment. 2. Stated on the plate will be the Model, date

17 4.3 Steering Control Levers The ZTO’s speed and direction are controlled by using two steering control handles. The handles can be moved forward

Wright Manufacturing Inc. Foreword Welcome to the progressive group of mowing professionals who use Wright mowers. We are focused on giving you a

18 4.6 Digital Hour Meter The ZTO is equipped with a digital hour meter. Refer to operating/reset instructions below. The programming specified is:

19 4.9 Safety Switch System The Wright ZTO is equipped with a safety interlock system. The PTO must be disengaged, an operator in the seat and the

20 5.2 How to start the mower Before starting the engine • Make sure the control levers are in the Parked/Brake, outward position • Turn OFF th

21 WARNING 5.5 Driving the Mower Over a Curb To climb a curb, first see the Safety Instructions section of this manual, especially the parts on:

22 WARNING 5.8 How to Perform the Tracking Adjustment First ensure that the tire pressure is equal on both rear drive tires (18-22 psi). Drive

23 WARNING 6 SERVICE AND ADJUSTMENTS 6.1 Tire Maintenance and Pressure Excessively worn tire tread is dangerous on all hills. Replace drive ti

24 6.3 Belt Tension Adjustment The pump drive belt is self-adjusting, and requires no adjustment. The blade drive belt is self-adjusting also and re

25 WARNING WARNING 6.5 How to Move the Mower if the Engine Won’t Start Remove the R-clip from the neutral release arm (bypass valve). Pull

26 WARNING WARNING Left Transaxle Right Transaxle Expansion tank Filter Guard and Filter Filter Guard and Filter Expansion tank Vent Plug (a

27 WARNING WARNING 6.10 Cutting Blades In order to maintain to best cut, it is important that the blades are well sharpened and not damaged.

1 TABLE OF CONTENTS PRE-DELIVERY SERVICE OF MOWER BY DEALER ...

28 This symbol means ATTENTION! YOUR SAFETY IS INVOLVED. The message that follows the symbol contains important information about

29 Dust Filter Vent / Purge To Tank 6.14 Spindle and Drive Pulley Split hub R&R • Remove 2, ¼” bolts from split hub and install in threaded hol

30 6.16 Kawasaki / Briggs & Stratton Engine Manual / Maintenance It is very important that all users of this unit read and understand the Kawasa

31 Maintenance ChartFirst 5 Hours Change oilEvery 8 Hours or Daily Check engine oil level Clean area around muffler and controls Cle

32 7 Electrical Schematic

33 P/N Description11990116 BOLT, HEX 5/8 - 11 x 1 1/2 Z513990007 BLADE SPACER, 5/8 X 1/413990039 WASHER, 5/8 Z817460012BUMPER, RUBBER, BLACK17460017

34 9 Decals

35 MAINTENANCE ITEMENGINE ITEMSSEE NOTE BELOWFIRST 8 HOURSDAILYEVERY 25 HOURSEVERY 100 HOURSEVERY 200 HOURSEVERY 300 HOURSANNUALLYInspect for cracks

36 Maintenance Record Date Maintenance/Service PerformedUnit HoursShop/Technician

37 Wright Manufacturing, Inc. (hereinafter: WMI) warrants to the original owner that the new WMI mower accompanying this document

2 6.9 Battery Service ...

38 FEDERAL AND CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The United States Environmental Protection Agenc

39 (2) Any warranted part that is scheduled only for regular inspection in the written instructions supplied is warranted for the warranty period st

40 Problem Description Possible Cause SolutionStreaking is when strips of uncut grass are left behind. Blades are not sharp Sharpen bladesBlades a

41 NOTES:

42 NOTES:

43 NOTES:

44 NOTES:

45

46 4600X Wedgewood Blvd Frederick, MD 21703 www.wrightmfg.com

3 PRE-DELIVERY SERVICE OF MOWER BY DEALER Before proceeding with the Pre-Delivery Service of your mower, please read the safety instructions manual

4  Turn on the blade clutch switch. Run blades for approximately one minute. Next, engage and disengage the blades a few times about 10 seconds ap

5 1 Introduction This mower is built to the highest standards in the industry. However, carelessness or operator error may result in serious bodily

6 WARNING Do's Don'tsRead the operators manual before attempting to operate this machine Don't disable safety switchesUse all PPE

7 WARNING WARNING WARNING WARNING operation of this equipment and be sure they read and follow the instructions in this safety manua